RV / Marine Winterizing Products

Stock# 1585002
TAYLOR MADE^® Marine de-icer with 3/4 HP 'Oil-Free' motor (115v / 60Hz) and 50' oil-resistant power cord. Keeps the water surface area ice-free. D-Icer™ is ideal for use around boats and docks, freshwater or saltwater. Suggested area of coverage: 50 - 70 ft. diameter

Stock# 1585003
TAYLOR MADE^® Marine de-icer with 1 HP 'Oil-Free' motor (115v / 60Hz) and 50' oil-resistant power cord. Keeps the water surface area ice-free. D-Icer™ is ideal for use around boats and docks, freshwater or saltwater. Suggested area of coverage: 70 - 100 ft. diameter

Stock# 1585006
Outdoor temperature controlled thermostat turns on at 25° f / off at 35° f. Just plug in the D-Icer and have peace of mind the unit will only run when necessary. Standard 3-prong plug works will all 120v Taylor D-Icers.

Stock# 1585007
Taylor Made two-piece zinc anode attaches to the motor shaft to ward off corrosion. Zinc anode works will all Taylor D-Icers and Aerators.

Stock# 1585024
Outdoor temperature controlled thermostat turns on at 30° f / off at 40° f. Just plug in the D-Icer and have peace of mind the unit will only run when necessary. Standard 3-prong plug works will all 120v Taylor D-Icers.

Stock# 1585011
Stainless Steel dock/piling mounting kit allows for precise angle, direction & depth of D-Icer. Dock mount kit works will all Taylor Made D-Icers.

Stock# 1585008
Taylor made replacement plastic propeller attaches to the motor shaft. Prop works will all Taylor 1/2 HP D-Icers and Aerators.

Stock# 1585009
Taylor Made replacement plastic propeller attaches to the motor shaft. Prop works will all Pyramid 3/4 HP D-Icers and Aerators.

Stock# 1585010
Taylor Made replacement plastic propeller attaches to the motor shaft. Prop works will all Taylor 1 HP D-Icers and Aerators.

Stock# 1609573
Simple, permanent installation of this kit allows you to easily drain your water heater for winterizing. Brass valves provide non-restrictive flow. Comes with crimp-resistant nylon reinforced hose.
Includes 8" hose for use with 6 gallon tanks

Stock# 1609574
Simple, permanent installation of this kit allows you to easily drain your water heater for winterizing. Brass valves provide non-restrictive flow. Comes with crimp-resistant nylon reinforced hose.
Includes 12" hose for use with 10 gallon tanks

Stock# 1609575
This temporary by-pass kit allows you to hook up for winterizing and remove in the spring for reconnecting the system. Comes with crimp-resistant nylon reinforced hose.

Stock# 1609576
Save on antifreeze when you winterize with this easily-installed water heater by-pass kit. Sturdy, brass backflow preventer and 100% shut-off valve lets you by-pass the water heater with a single turn.

Stock# 1609577
Pump antifreeze directly into your RV waterlines and supply tanks. Kit comes with flexible connecting line, city water connection and water faucet adapters.

Stock# 1609578
Winterize your RV annually with ease. This permanent kit installs with an adjustable wrench and comes complete with brass valve, siphon hose, thread-seal tape and pump adapters.

Stock# 1609579
Protect your exposed pipes using Camco’s R-5 insulation with “Vapor Seal”.  Measures 3" x 25'
SUPPLIES LIMITED

Stock# 1609580
Completely clear your water lines with RV blow-out plugs. Screw the plug into the city water inlet, open all drains and faucets, attach and activate air pump until all lines are clear.

Stock# 1609581
Quickly and efficiently service inboard/outboard marine engines. The patented Do-It-Yourself Winterizer allows flushing and preparation of boat engine for winter storage with just five gallons of antifreeze and your flusher. Save time and money season after season. Great for technicians, too.

Stock# 5250005-ORMD
Protects outboard motors, marine engines & internal combustion engines during periods of storage, insures longer life. As long term metal protectant, it keeps pistons, rings & cylinder walls corrosion free.
NOTE: SHIPS BY UPS GROUND SERVICE ONLY

Stock# 5250028-ORMD
Use injection can with hose to fog Evinrude and Johnson motors 1990 and newer equipped with a maintenance valve. CRC marine engine stor flogging fluid is a oil lubricant that protects outboard motors, marine engines and internal combustion engines.
NOTE: SHIPS BY UPS GROUND SERVICE ONLY

Stock# 5250011-ORMD
A long term, flexible corrosion inhibitor that protects & preserves metal surfaces, electrical connections, engine components & fasteners, subject to salt spray and high humidity. Also effective for steering & throttle linkages.
NOTE: SHIPS BY UPS GROUND SERVICE ONLY

Stock# 1576167
The Salt Terminator from CRC cleans and protects anything exposed to salt. Made to dissolve salt while leaving a long lasting protective coating. Perfect for boats, PWC's, trailers, fishing tackle, autos, RV's, trucks, tools, motorcycles, atv's, bicycles and much more.

Stock# 5135023
Ideal for adding oil and other fluids to small engines and marine lower units. Flexible hose for hard-to-reach fill plugs. 4 cc Pump and 3/8"-16 swivel metal marine filler fitting.

Stock# 5135034
The lower unit lube pump adapter is a 8mm x 1.25" thread that fits Yamaha, Tohatsu, Nissan and Honda (2-50 h.p.) lower units.

Stock# 5135004-ORMD
Lubrimatic high-viscosity 80w/90 lower unit gear lube protects lower units in ordinary and extreme operating conditions. Special additives included to helps against wear, rust and corrosion.
NOTE: SHIPS BY UPS GROUND SERVICE ONLY

Stock# 5135051-ORMD
POWER-PRO Synthetic Blend Lower Unit Gear Lube. Ideal for modern outboard and stern drive lower units.
NOTE: SHIPS BY UPS GROUND SERVICE ONLY

Stock# 5135011-ORMD
Outboard or I/O power trim and tilt pump fluid for all marine motors. Formulated to provide viscosity and lubricity necessary to ensure proper pump performance and seal life. Combats high operating pressures and resists rust.
NOTE: SHIPS BY UPS GROUND SERVICE ONLY

Stock# 5229214
Provides clean method of emptying oil from inboards and inboard/outboard engines. Fits dipstick tube of engines. Also fits built-in screw fitting on recent inboard/outboard models.

Stock# 5006012
Siphon-Mate® pump is a combination displacement lift pump and siphon pump with valves suitable for transferring Diesel, Oil & Water.

Stock# 5212005
12 volt engine oil change pump with quick connect battery clamp wire and on/off switch. Provides clean method of emptying oil from inboards and inboard/outboard engines. Fits dipstick tube of engines.

Stock# 5308011
Self Priming, 200 GPH pump attaches easily to any electric drill. Changes motor oil, water systems and most other non-flammable fluids. Features include 1/4" Drill Shaft and an 8' to 10' prime draw length.

Stock# 5308012
Self Contained, 3.75 GPM 12 volt pump with a hose kit and 3-1/2 gallon storage container. Changes motor oil, water systems and most other non-flammable fluids.

Stock# 1576170
The Panther fluid extractor is designed to extract fluids from inaccessible or confined areas. Works on boats, cars, motorcycles, outdoor power equipment, industrial machinery.

Stock# 1576169
The Panther fluid extractor is designed to extract fluids from inaccessible or confined areas. Works on boats, cars, motorcycles, outdoor power equipment, industrial machinery.

Stock# 1354002
Helps prevent mold and mildew in enclosed spaces. Designed for safe continuous operation, the DryWave Air Dryer has no moving parts and incorporates a thermal cut-off switch to prevent overheating.

Stock# 1015533
Slow Release System is the most effective way to eliminate and prevent foul odor from an enclosed area while also maintaining air quality. It is the most effective way to prevent odor from forming in boats or RVs in long-term or seasonal storage. It is also ideal for year-round use in boats, RVs or homes. It is also great for maintaining air quality in storage areas, cars, vacation homes, basements or any other enclosed area. 2-pack Treats 10' x 10' x 10' area each

Stock# 1015534
Fast Release System an effective way to remove foul odor from an enclosed area. It will treat an area within 6 hours. It is ideal for eliminating odors from storage areas, cars, vacation homes, basements or any other enclosed area. It is also great for removing odors from boats or RVs that have been in long-term storage. Treats up to 10' x 10' x 10' area

Stock# 1015535
Deep-Penetrating, quick-release vapor quickly removes foul odor in areas up to 10' x 10' x 10' in 4 - 6 hours. Ideal for removing mold/mildew and unpleasant odors from boats or RVs that have been in long-term storage. Also great for eliminating odors from storage areas, cars, vacation homes, basements or any other enclosed area.

Stock# 5020616
The Water Wick absorbs moisture from the air which helps control and prevent mold & mildew. Designed for use in RV´s, Trailers, and Boats. Contains 1.65 lbs./750 grams of Calcium Chloride that can absorb up to 2-1/4 liters of moisture.
SUPPLIES LIMITED

Stock# 1015111
Absorbs moisture to help prevent mildew. Keeps your boat or RV fresh and clean smelling by absorbing more than it's own weight in humidity. 12oz. container treats 900 cubic feet.

Stock# 1015110
Absorbs moisture to help prevent mildew. Keeps your boat or RV fresh and clean smelling by absorbing more than it's own weight in humidity. 36oz. container treats 1800 cubic feet.

Stock# 1015114
Chemical refill for the No-Damp 12 oz. tub. When absorption performance diminishes, re-fill ingredient may be added right on top of remaining chemical.

Stock# 1015166
Chemical refill for the No-Damp Buckets. When absorption performance diminishes, re-fill ingredient may be added right on top of remaining chemical.

Stock# 1582127
Universal round cup motor flushers are for use on all lower units with side water inlets. Install in seconds using just a garden hose.

Stock# 1582128
Universal rectangular cup motor flushers are for use on all lower units with side water inlets. Install in seconds using just a garden hose.

Stock# 1582129
Universal dual feed rectangular cup motor flushers are for use on all lower units with side water inlets. Install in seconds using just a garden hose.