Trailer Parts Superstore® offers a selection of weight-distribution hitch accessories to assist in towing and trailering of your camper, utility trailer, landscaping trailer or horse trailer.
Stock# 7155011 FREE GROUND SHIPPING TO LOWER-48 U.S. TPS weight distribution hitches come with a 2" x 2" shank and are compatible with class 3, and most class 4 trailer hitches, as well as some RV trailer hitches. it features 8 inches in total height adjustment, rise is 5-5/8 inch, drop is 2-3/8 inch.
Stock# 7003156 Towing your camper trailer is easy with this all-in-one kit. It is ideal for vehicles weighing less than 5,000 lbs. and trailers between 3,500 and 5,000 lbs. However, the components within the kit are tested and rated for up to 7,500 lbs. maximum.
Stock# 7003101 CURT trunnion bar weight distribution hitch features a heavy-duty formed head and square spring bars constructed from forged steel. It offers a gross trailer weight capacity up to 15,000 lbs. and a tongue weight capacity of 1,500 lbs.
Stock# 5223317 Pro Series™ Friction Sway Control kit will help reduce the affects of induced sway by using friction. It works by stiffening the connection between the tow vehicle and the trailer.
Stock# 7003107 Shaft Diameter = 5/8", Shaft Length = 1-3/4". CURT sway control replacement ball is designed to attach a sway control unit to the vehicle-side of the connection. With its 5/8" shank diameter, it mounts into the mounting tab of a weight distribution hitch or a sway control ball mount. It features a ball diameter of 1-1/4" to fit the CURT sway control unit #17200.
Stock# 7003105 Curt weight distribution shank is 13-1/4" high by 11" long overall. Each hole in the vertical shank has a 3/4" diameter, and they are spaced 1-1/4" apart for a wide range of incremental adjustment of the WD head. With an overall height of 13-1/4", this WD shank provides a maximum rise of 10-1/2". The entire shank can also be flipped in the receiver tube to provide a maximum drop of 7".
Stock# 7003106 Curt weight distribution shank is 14-1/2" high by 12-1/2" long, measured from the outermost holes center-to-center. Each hole in the vertical shank has a 3/4" diameter, and they are spaced 1-1/4" apart for a wide range of incremental adjustment of the WD head. With an overall height of 14-1/2", this WD shank provides a maximum rise of 8".
Stock# 5223305 DRAW-TITE Sway Control Adapter Bracket slips over class-III and class-IV 2" square ball mounts and is held in place when the trailer ball is tightened down.
Stock# 1623511 Weight Distribution Replacement Pins from J.R. Products is zinc plated and designed to replace most weight distribution pins. Measures: 3/16".