When using a poly tarp to cover your boat consider the following tips to maintain during storage. • Always support the cover from underneath, preferably the entire length of the boat, so that rain and snow will not form puddles on top of the cover. • Cover any sharp edges such as cleats and windshields with a cloth rag to prevent tears in the poly tarp material. • Secure all tie down points snuggly! A tightly attached tarp is the best protection against wind damage, the leading cause of tarp failure.
Stock# 5229227 ATTWOOD Boat Cover Support Kit is an easily adjustable cover support system to keep water from accumulating in center of cover. Extends the life of any boat cover by as much as 50%. This cover support system uses a 1" diameter telescoping pole (28"-48"), 1" wide poly web straps, and a bow spreader to form a double ridge line under the cover.
Stock# 5341038 Trailering tie down kit attaches to almost any boat cover that has sewn in tie-down loops. Durable quick release buckles at each end of strap. Designed to go thru loop and around trailer frame. SUPPLIES LIMITED
Stock# 5341039 CARVER boat cover support pole is made of 4 anodized aluminum poles that adjust the cover 40" to 70" in height. Assembly includes a rubber end cap on the bottom pole and a rubber guide tip on the top pole. Guide tip is designed to mount through grommet installed on cover (Grommet not included). SUPPLIES LIMITED
Stock# 5341040 CARVER vented boat cover support pole is made of 4 anodized aluminum poles that adjust the cover 40" to 70" in height. The add-on poles telescope from the base while locking into place with a push of a lever. The vent attaches to the top pole through the boat cover material reducing moisture, heat and mildew under the cover. SUPPLIES LIMITED
Stock# 5336230 Quick, easy boat cover center support made of rust-free ABS plastic. Comes with a 9" base, 5" topper with strap slots and six 8-1/4"H x 1-1/2" diameter add-on poles raising the cover (12" to 54").
Stock# 5229169 Quick, easy boat cover center support. 1" diameter anodized aluminum pole telescopes to raise cover (36" to 64"). Locks and unlocks with a twist. Rubber tips at both ends.
Stock# 1536148 Plastic Cover Support Cap fits snugly over a 2x4 piece of wood. Provides more support surface area than a standard telescoping pole. Works best when used on top of a cut length of 2x4 lumber.
Stock# 1536253 Plastic Cover Support Base fits snugly over a 2x4 piece of wood. Provides more support surface area than a standard telescoping pole. Non-skid pads help keep the base secure.
Stock# 5282157 Boat cover support slat sockets with 2 hole screw mount, chrome zinc plated finish (1 pair). Bow Slat Sockets are used to support fiberglass or wood cover support bows. Mounting screws not included.
Stock# 5049020 HandiMan Marine EZ Grommet Kit allows for easy replacement or addition of a grommet, includes six 1/2" I.D. plastic eyelets, steel hole punch, and wooden base.